probleme de trigger

jai un petit probleme avec mon trigger sur ma browning x-bolt je le trouve vraiment trop raide jaimerait l'attendrir je ne sait pas comment faire est ce que je peut faire sa moi meme cest tu bien compliquer ou il faut que j'aille voir un armurier

le mieux est d'aller voir un armurier pour une job sécuritaire.

Ok merci encore des cristi de places qui vont arvoler !!

juneg a écrit:

jai un petit probleme avec mon trigger sur ma browning x-bolt je le trouve vraiment trop raide jaimerait l'attendrir je ne sait pas comment faire est ce que je peut faire sa moi meme cest tu bien compliquer ou il faut que j'aille voir un armurier

a l'achat il y avai t'il un depliant de l'arme qui parle du trigger et autre piece

je vais verifier mais je croit que oui

bon je reussi pas a resizer sa la

Before adjusting the trigger, Always place the “safety” in the
on safe position. keep the muzzle pointed in a safe direction
and your fingers away from the trigger. Failure to follow
these warnings could result in serious injury or death.
ALWAYS INSPECT THE CHAMBER, barrel and mAGaZINE CAREFULLY
AFTER UNLOADING TO BE SURE ALL LIVE cartridges ARE CLEARED

FROM THE firearm.
The X-Bolt’s trigger is pre-set at the factory. The trigger pull weight
can be adjusted within a range of approximately 3 to 5 pounds, and is
factory pre-set at 4 pounds. Though additional trigger adjustments
should be unnecessary, the trigger pull weight can be tuned to your
specifications by performing the following procedure:

1 Remove the magazine from the rifle by pressing the magazine
release button. Open the bolt and verify the rifle is unloaded.

2 Remove the two screws that retain the bottom metal with a 4mm
Allen wrench (Figure 10). Lift the bottom metal out of the stock

3 The trigger pull adjustment screw is located just in front of the
trigger (Figure 11). To increase the weight of the trigger pull, turn
the adjustment screw in a clockwise direction using a 2mm Allen
wrench. To decrease the weight of the trigger pull, turn the
adjustment screw in a counterclockwise direction. NOTE: If trigger
pull is increased too much, the trigger cannot be pulled. Turn the
screw counterclockwise until trigger can be pulled.

4 Trigger pull can be measured, with the rifle unloaded and the
bolt closed, using a very accurate spring scale or a commercially
available set of trigger pull measuring weights. Most gunsmiths
can also measure trigger pull for you.

5 When finished making the adjustment, replace the trigger guard
back in the stock and reinstall the trigger guard screws snugly.

tes un surhomme 1cd merci !!

Ça me fait plaisir de te donner un coup de main mon ami

juneg a écrit:

je vais verifier mais je croit que oui

note je vais a SANDHILL samedi j'y serai vers 9 1/2 hrs ci tu viens j'aurais mes outils pour mesurer le tension du trigger et le torque outils pour reserrer tes bolt de l'action a la bonne tension